Georgian Brass Square Grilles Style Table
If you cannot see your desired combination above, you can specify your Georgian brass preference using the following notation:
 
GRILLE STYLE / SQUARE SIZE / ROSETTE STYLE / MESH SIZE (See examples above)

Georgian Natural Brass = GGB

Plating and treatments available:

Georgian Polished Nickel = GGNK

Georgian Satin Nickel = GGSNK

Georgian Bronze Metal Antique (BMA) = GGBZ
BMA is an even black finish

Georgian Polished Chrome = GGCH

Georgian Satin Chrome = GGSCH

Georgian Antiqued Brass = GGAB
Antique brass is a brown finish with flecks of natural brass showing through

Georgian Pewter = GGPT

(Unless requested otherwise, rosettes / rivets and mesh are always assumed to be the same finish choice.)

25mm 

41mm

54mm

All Rivets = RIV

All Plain = PLR

*Alternate Plain = APLR

All Floral = FLR

*Alternate Floral = AFLR

All Oxford = OXR

*Alternate Oxford = AOXR

All Honeycomb = HOR

*Alternate Honeycomb = AHOR

*Georgian grille alternate rosette placement is not on an alternate line basis as with Regency grilles but on a "hit and miss" basis.
On each horizontal line there will be rosette, then rivet, then rosette, then rivet.
The line below will be offset to interleave this as shown below:

Notes:
Plating and treatments are processes that increases price and delivery time.

You may also choose contrasts of the main square and backing mesh finish.

Notes:
Georgian grilles apart from polished chrome and polished nickel are treated with a fine clear lacquer to enhance and maintain their appearance unless requested otherwise.

Notes:
Georgian grilles apart from polished chrome and polished nickel are treated with a fine clear lacquer to enhance and maintain their appearance unless requested otherwise.

Additional Technical Information:

• Maximum size of any Georgian Square grille is 1600mm x 900mm
• Georgian brass grilles are manufactured symmetrically in both horizontal and vertical planes (Height and Width). Grilles will therefore match if paired (when manufactured on the same order).
• Your decorative grille will be manufactured to the size requested. We do not add an additional fixing border which you will need to include in your dimensions. (approx. 15 to 20mm all around in a typical application).
• To allow flush fixing behind an aperture, rosettes are replaced by rivets within approx. 15 to 20mm of the grille edge but this will depend on diamond size and grille dimension. (Grilles are typically installed with a small screw and washer though the backing mesh at the rear edge, at approx. 40mm intervals. There is no need to rebate the grille behind the aperture unless the rear will be visible and you wish to provide a neater finish. Using wooden beading around the edge is an option often chosen in this situation. You may however, fit how you wish. No fixings, beading or framing is supplied).
• The depth of this grille at the edge, is approx. 5mm, depending on your style choices. (3mm square brass rod + mesh backing at 0.7mm or 1mm (fine/large) + a possible rivet head with it's turned down pin at the rear. Total = approx. 5mm). At the point of a rosette, depth is approx. 6mm.
• Please note that this style of grille one displayable face. These grilles are constructed using traditional methods and the rear of the grille contains pins from your chosen rosette/rivet which secure the lattice construction and hold the backing mesh in place (if specified). Rosette/rivet pins by design have points which are turned down flush to the rear. This may be a consideration for you depending on your application.
  Please CLICK HERE to view the rear of an example Regency brass grille which is of similar construction.
  (Not all pins penetrate the backing mesh which is due to the stages required in the build up of the product and is normal)
• Grilles are made to a tolerance of + /- 2mm per supplied dimension.